Etwin; Co N T Ro L Pan E L; Diagram Of The Electrical Connections - ETATRON D.S. eTwin Notice D'installation, Emploi Et Entretien

ETWIN

Co n t ro l Pan e l

The following figure depicts the control panel with the description of the functions of the different keys.

DIAGRAM OF THE ELECTRICAL CONNECTIONS

To connect the accessories and peripheral devices to the pump, remove the front cover, acting on the two plastic screws on the
sides of the cover with a flat headed 5mm (at least) screwdriver to reach the terminal board.
The terminal board consists of spring terminals for quick coupling of the wires. Press the square "slotted" pin with a small flat
headed screwdriver and insert the stripped wire in the corresponding terminal. ATTENTION: exert slight pressure on the spring pin
to avoid irreparably damaging the terminal board.
Pass the cables through the rubber cable glands on the wall of the cover, using a screwdriver to remove the thin internal closing
septum. Pay attention to perforation of the cable gland and wear appropriate protective equipment (gloves).
Fig. 6 – Control Panel
Fig. 7 – Opening terminal board cover and position of probe connectors
1 Increase values button
2 Decrease values button
3 MENU - ESC button
Calibration (CAL) of
4 instrument and OK
confirmation button
Set-point display and
5
setting button
6 Digital screen
ENGLISH
45