Prescribed Use; Setting Elements (Fold-Out Page) - VOLTCRAFT LCR 4080 Notice D'emploi

Prescribed Use of the LCR – Measuring
Instrument 4080:
Measuring unipolar or bipolar capacitor (C) of approx. 5 pF up to 10000 µF= 10 mF
Measuring resistors (R) up to max. 10 MOhm
Measuring inductors (L) up to 10000 H
It is not admissible to carry out measurements in wet rooms or outdoors or
under adverse environmental conditions. Adverse environmental conditions
are:
- dampness or high humidity
- dust or inflammable gases, vapors or solvents
- thunderstorms and stormy conditions like strong electrostatic fields
Any other use than the one described above damages the measuring instru-
ment. Moreover, this involves dangers, such as short-circuit, fire, electric
shock, etc. No part of the product may be modified or rebuilt!
Observe the safety instructions and technical data.

Setting Elements (fold-out page)

1. -On/ off button
2. "FREQ" button for changing the measuring frequency
3. "PAR / SER" parallel / Series button (high or low impedance)
4. "RANGE" button for a manual or automatic range selection
5. "L/C/R" button for changing from the measuring of inductors "L"
to the measuring of capacitors "C"
or the measuring of resistors "R"
6. "Q/D/R" button for reversing the corrective factors for the parallel or
series measurement:
Q for the quality,
D for the dissipation factor (= 1/Q)
and R for the parallel or series resistor
25