VOLTCRAFT LCR 4080 Notice D'emploi page 26

7. >2 sec HOLD" button for the background lighting and/or the hold-
function (freezes the measured value)
8. "MIN MAX" button for the maximum value - (MAX),
the minimum value – (MIN) and
the average measured value (AVG)
9. "SET" button for the setting mode for the "Hi / Lo" functions (above or
below a set limit),
"REL" (measuring relative to a reference value)
and "TOL" (measuring within tolerances)
10. "REL" button for reference measuring
11. "Hi / Lo" button for setting the upper and lower limits in
connection with the "SET" button
12. "TOL" button for tolerance value measuring
13. "+ / –" base with contact slots for measuring components with suffi-
ciently long terminals
14. "+ / –" measuring input for connecting the instruments leads
15. Battery compartment (under the holster in the bottom side of the instru-
ment)
16. Serial RS-232 interface and DC-input (polarity "+" inside)
17. LCDs, main display and sub-display (small), 2 x 4
value to be displayed: 19999
APO AUTO POWER OFF display
RS 232 interface on display
R Display symbol for the MIN – MAX value input
MAX Display symbol for the maximum value
MIN Display symbol for the minimum value
AVG Display symbol for the average value
AUTO Display symbol for the automatic range selection
26
/ -digit, maximum
1
2