VOLTCRAFT LCR 4080 Notice D'emploi page 33

When you press the button once again, the difference of MAX minus MIN will
be displayed,
when you press it the next time, the average value AVG will be displayed.
After 2991 average values, the display symbol "AVG" will begin to flash. After
3000 average values the average values will be stopped.
To leave the function, keep the button "MIN MAX" pressed for 2 sec. once
more. The symbol "REC" will disappear, the recording of the measured values
is terminated, the 3000 AVG values are erased, and the MIN and MAX values, too.
The second function of the button is the number "5".
D9 "SET" button
You will need the "SET" button for the sub-functions open calibration, short
circuit calibration, setting Hi / Lo limits, setting a tolerance range (TOL) and
setting the reference value.
Switch the measuring instrument on and press the "SET" button. The main
display will disappear, on its left the flashing arrow symbols "^" and "
appear, the small sub-display will show "SEt" and also the flashing symbol ∅
"TOL".
D9 a) For the open calibration, press the "SET" button once. In the large
digital display, "OPEn" appears, in the small digital display (sub-dis-
play) "CAL" (for calibration).
Press the "PAL SER" button for confirmation (ENTER).
After a relatively short time, "Out" will be displayed in the small and
"UAL" in the large display. The calibration is out of the limits. IF the
calibration was successful, the measuring instrument would leave the
set mode immediately and return to the normal mode.
D9 b) For the short calibration, short-circuit the measuring leads and press
the "SET" button twice. The large display will show "SHrt", in the small
one, "CAL" will be displayed. Press the "PAL SER" button for confir-
mation (ENTER). After a relatively short time, the frequency display will
change (at the right of the large digital display) from 1 kHz to 120 Hz,
and after a successful calibration, the instrument leaves the set mode.
You can carry out the measurement.
If – instead of the normal mode - "Out" appears in the small display
and "UAL" in the large one, the calibration was not
example the measuring leads were open. Shortly afterwards, "CAL"
and "SHrt" will reappear.
" will
successful, for
33