Gallignani GA FB 12 Manuel D'utilisation Et D'entretien page 138

TROUBLESHOOTING
PROBLEM
Frequent clogging of feeding.
E
N
G
L
I
S
H
PROBLEM
Too noisy power take--off tran-
smission shaft.
Frequent breakage of torque li-
miters (shearbolts).
5- -2
STUFFER
POSSIBLE CAUSE
Irregular swaths or crop not
evenly dried.
Incorrect adjustment of the win-
dguard.
The baler tow hook and the
steering shaft are too close to
the ground.
Too high speed on irregular
grounds.
Wet, irregular and uneven
swaths.
Forward movement on one side
of the swath.
Foreign bodies in the crop.
Too much crop.
TRANSMISSIONS
POSSIBLE CAUSE
Incorrectly positioned fastening
points.
Telescopic pipes not lubricated. Regularly grease the telescopic
Worn guards.
Worn spiders.
Too high density.
REMEDY
Produce even swaths, well ai-
red.
Reduce the inching speed.
Adjust stroke and pressure of
the windguard.
Connect the baler as recom-
mended.
Reduce the inching speed.
Let the swaths dry and make
them evener, or reduce the in-
ching speed.
Move in the middle of the swath.
Remove foreign bodies.
Reduce the inching speed.
Make smaller swaths.
REMEDY
Adjust the fastening hook as
specified.
pipes.
Replace the guards.
Replace the spiders.
Reduce the bale density.
Page
3--2
4--3
2--4
--
3--2
3--3
--
3--2
Page
2--4
4--6
--
--
2--8