Tractel blocstop BS Mode D'emploi page 18

Appareil antichute
Table des Matières

Publicité

• The technical characteristics of the BLOCSTOP
Model
WLL (kg)
15.301
600
20.300
600
15.303
800
20.303
800
20.304
1 000
20.301
1 200
35.304
2 000
35.30
2 400
WLL: Working Load Limit for man lifting.
GB
WLL*: Working Load Limit for material's lifting and pulling.
W: Weight of fall arrest device.
Øc: Wire rope diameter.
R: Minimum tensile strength of wire ropes.
St: Structure of wire ropes.
The wire ropes (ordered separately) are supplied on a reel with safety hook at one end (item A, fig.16) or with a sleeved and
thimbled end (item B, fig. 16) on request.
• The dimensions (in mm) of the BLOCSTOP
TM
devices are as follows:
Series
BS 15
BS 20
Fig.
n
24
o
a.
161
203
b.
167
210
c.
209
252
d.
91
121
Øe.
12
12
o.
74
74
g.
64
74
h.
38
38
i.
20
19,5
j.
14
25
k.
42,5
55
l.
39
50
l*.
100
145
m.
33
45,5
m.*
39
52,5
r.
19
19
Øs
12,2
12,2
Table 4
(*): Position of stirrup used to unlock fall arrest device.
BSA fall arrest devices are as follows:
TM
W (kg)
Øc (mm)
St
R (kg)
4
8,3
5 x 19
4 800
6
8,3
5 x 19
4 800
4
9,5
5 x 19
6 400
6
9,5
5 x 19
6 400
6
10,2
5 x 26
8 000
6
11,5
5 x 26
9 600
10,6
14,3
5 x 26
16 000
10,6
16,3
5 x 31
19 200
Table 3
BS fall arrest
• The dimensions (in mm) of the BLOCSTOP
devices are as follows:
BS 35
Series
BSA 15
BSA 20
n
25
Fig.
n
11
n
12
o
o
o
290
a.
161
203
297,5
b.
91
121
375,5
c.
34
37
140
d.
14
25
22
e.
19
29
115
f.
100 ± 3
100 ± 3
90
g.
173
222
60,5
h.
146
179
22
i.
20
19,5
28
j.
106,5
157,5
60
k.
287
345
12,7
o.
75
75
157
o'.
-
-
90
p.
40
40
84
q.
27
27
27,5
Ør
64
64
22,2
Øs
12,2
12,2
t
42,5
55
Table 5
- 18 -
10. INSPECTION AND MAINTENANCE SHEET
The inspection and maintenance sheet is located at the end of this manual.
11. MALFUNCTIONS
Malfunction
Seizure: the fall arrest wire rope
does not slide in the fall arrest
device (BS or BSA)
TM
BSA fall arrest
BSA 35
n
13
o
BSA fall arrest device locks for a
suspended platform inclination
290
greater than 14°/horizontal
140
53
28
22
200 ± 5
313
270
22
222
395
90
75
40
27
No locking action: fall arrest device
(BS or BSA) does not lock
64
22,2
60
Sliding of roller on wire rope
(*): Return to TRACTEL
Diagnostics
Cable damaged
Immediately stop the manoeuvre
- set the load on the ground,
- withdraw the wire rope from the unit,
- scrap the wire rope and replace it by a wire rope
in good condition,
- send back* the fall arrest device for inspection.
Jaw mechanism failure
(1) Immediately stop the manoeuvre
- set the load on the ground,
- withdraw the wire rope from the unit,
- send back* the fall arrest device for inspection.
Ballast weight not correctly
Immediately stop the manoeuvre
positioned
- position the ballast weight as instructed in the
lifting installation manual,
- perform functional checks on the fall arrest
device as instructed in §9.
Wire rope entry or exit holes
Immediately stop the manoeuvre
are obstructed or soiled
- set the load on the ground,
- withdraw the wire rope from the unit,
- clean the wire rope holes on the unit,
- reinstall the wire rope in the unit,
- perform functional checks on the fall arrest
device as instructed in §9.
Distance (f) not observed
Immediately stop the manoeuvre
- modify lifting system to observe distance (f) as
instructed in §5.2.1,
- perform functional checks on the fall arrest
device as instructed in §9.
Wire rope worn
(2) Immediately stop the manoeuvre
- set the load on the ground,
- withdraw the wire rope from the unit,
- scrap the wire rope and replace it by a wire rope
in good condition.
Jaws worn or seized, or lever
See corrective action (1) above.
pin seized, or return spring
broken
Mounting part connecting fall
Immediately stop the manoeuvre
arrest device to suspended
- set the load on the ground,
platform is bent
- replace mounting part by a part in good
condition,
- perform functional checks on the fall arrest
device as instructed in §9.
Jaws worn or seized, or
See corrective action (1) above.
stirrup pin (BS) or lever pin
(BSA) seized, or return spring
broken
Wire rope worn
See corrective action (2) above.
Roller seized
See corrective action (1) above.
®
or approved repair agent.
- 23 -
Corrective actions
GB

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Blocstop bsa

Table des Matières