Cleaning The Machine And The Engine; Cleaning And Lubrication Of The Cutting Means; Nuts And Bolts; Occasional Maintenance - Stiga HT 900 Li 48 Manuel D'utilisation

7.2.2 Battery removal and recharging
1. Press the locking button located
on the battery (Fig. 13.A) and
remove the battery (Fig. 13.B);
2. Fit the battery (Fig. 14.A) in the battery
charger compartment (Fig. 14.B);
3. Connect the battery charger (Fig. 14.B)
to a power socket with the voltage
indicated on the rating plate;
4. Fully charge the battery according to the
instructions in the battery charger manual.
NOTE
The battery is equipped with a protection device
that inhibits recharging if the environmental
temperature is not between 0 and +45°C.
NOTE
The battery can be charged at any time,
even partially, with no risk of damaging it.
7.2.3 Refitting the battery in the
battery backpack
When recharging is completed:
1. Remove the battery (Fig. 15.A) from the
housing in the battery charger (do not keep
charging when recharging is completed);
2. Disconnect the battery charger (Fig.
15.B) from the electrical mains;
3. Insert the battery (Fig. 4) in one of the
compartments of the battery backpack
and push it completely, until hearing the
click that signals its locking in position,
ensuring thus the electrical contact.
7.3 CLEANING THE MACHINE
AND THE ENGINE
To reduce fire hazards, keep the machine
and, in particular, the motor free of leaves,
branches or excessive grease.
• Always clean the machine after use with a
damp cloth dipped in neutral detergent.
• Remove all traces of humidity using
a soft damp cloth. Humidity can
generate risks of electric shocks.
• Do not use aggressive detergents or solvents
to clean the plastic parts or hand grips.
• Do not spray water onto the motor
and electrical components and
prevent them from getting wet.
• To avoid overheating and damage to the
motor or the battery, always keep the
cooling air vents clean and free of debris.
7.4 CLEANING AND LUBRICATION
OF THE CUTTING MEANS
To increase the efficiency and working life
of the blades, clean and lubricate them
carefully after each work session:
DANGER
Do not touch the cutting means if the
machine is not disconnected from the
battery backpack and if the cutting means
is not completely at a standstill.
1. Place the machine in a stable
horizontal position on the ground.
2. Use a soft cloth to clean the blades,
along with a brush to remove
more difficult dirt and debris.
3. Lubricate the blades by applying a light layer
of specific oil, preferably the non-pollutant
type, along the upper edge of the blade.

7.5 NUTS AND BOLTS

• Keep all nuts, bolts and screws tight to be sure
the equipment is in safe working condition.
• Check regularly that the
handles are fixed firmly.

8. OCCASIONAL MAINTENANCE

8.1 CUTTING MEANS OCCASIONAL
MAINTENANCE
DANGER
Do not touch the cutting means if the
machine is not disconnected from the
battery backpack and if the cutting means
is not completely at a standstill.
If the blades are used correctly, following all the
instructions provided, they will not require any
maintenance work and will not need sharpening.
8.1.1 Checks
DANGER
Periodically check that the blades are
not bent, damaged or deformed and that
the screws are adequately tightened.
EN - 11