Table des Matières
Publicité
4.1 ASSEMBLY COMPONENTS
The package contains the machine
already assembled.
4.1.1 Unpacking
1. Carefully open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
4.1.2 Fitting the battery backpack
The battery backpack is delivered already
assembled
(Fig.
1.F) and can be released from
the strap support (Fig. 3) and carried by hand.
To release the battery backpack, press
on the two upper buttons (Fig. 3.A).
The battery compartments are located on
both sides of the backpack (Fig. 4).
The following can be found on the
right side of the backpack:
• cable socket (Fig. 5.A)
• battery selector (Fig. 5.B)
• one USB port for charging other devices
(e.g. mobile phones) (Fig. 5.C)
To avoid any loose cables, there are
grooves on both sides and at the rear, in
which the power cable can be inserted.
5. CONTROLS
5.1 BLADE CONTROL LEVER
(CUTTING MEANS)
Is used to operate/stop the blade.
It is only possible to activate the cutting
means (Fig. 1.B) when both the blade
control lever (Fig. 6.A) and the safety switch
(Fig. 6.B) are pressed simultaneously.
The cutting means stops automatically when
the lever or safety switch are released.
5.2 REAR HANDGRIP RELEASE LEVER
The release lever (Fig. 6.C) is used to adjust
the rear handgrip (Fig. 1.D) to 3 different
positions in relation to the cutting means
to make trimming your hedges easier.
5.3 CUTTING HEIGHT
ADJUSTMENT BUTTON
The cutting speed adjustment button (Fig. 6.D)
is used to select between the three speed levels
(Fig 6.E), depending on what you have to cut.
6. USING THE MACHINE
DANGER
The safety regulations to be followed are
described in chapter 2. Strictly comply with these
instructions to avoid serious risks or hazards.
6.1 PRELIMINARY OPERATIONS
Before starting to work, it is necessary to carry
out several checks and operations to ensure you
can work efficiently and in maximum safety.
1. place the machine in a stable
horizontal position on the ground;
2. check the battery (par. 6.1.1);
3. insert the battery correctly in
one of the compartments of the
battery backpack (par. 7.2.3 );
4. wear the
battery backpack
correctly (par 6.1.2).
6.1.1 Checking the battery
The machine is supplied without the battery.
Purchase the battery with the capacity that
most suits your operational requirements
and fully charge it according to the
instructions in the battery charger manual.
The list of approved batteries for this machine
can be found in the "Technical Data" table.
Before each use:
• Check the battery charge status by
following the instructions provided
in the battery charger manual.
6.1.2 Using the battery backpack
1. Insert the battery in one of the compartments
of the battery backpack and push it
completely, until hearing the click that
EN - 7
Publicité
Table des Matières
