Robert Juliat D'ARTAGNAN 930 SNX Dossier Technique page 27

3. USING THE " DIGI " MODE.
3.1.The ballast and the CAD are on ;
the " lamp on" command is given ,
but the lamp does not switch on.
Green &
red LED
o .
Green &
red LED
on.
3.2. Untimely extinction of the lamp.
Green
LED
on.
Green
LED
on.
robert juliat
Route de Beaumont F 60530 Fresnoy-en-Thelle phone: +33 (0)3.44.26.51.89 - fax: +33 (0)3.44.26.90.79 - www.robertjuliat.fr
DOSSIER TECHNIQUE
Green
message unchanged.
LED
on.
message displayed :
Green
RJ LAMP LIGHTING
LED
TRY FAILURE.
on.
message unchanged.
message unchanged.
message displayed :
LAMP FAILURE
CHECK SECURITY
message unchanged.
DECOUPES MSR 2500W
No circuit number "lamp channel"
assigned : refer to page 9 of the
CAD 900 manual.
Return to 1.1 and follow the
procedure.
Transmission Data error :
connection failure : check cable.
( refer to sections A - 5 & A - 11 ).
Transmission Data error :
connection faulty or damaged -
check the wiring.
Important disruption on the Data
line : check the installation.
Bad Protocol : refer to page 7 of the
CAD 900 manual.
Protocol recognition locked :
refer to page 15 of the
CAD 900 manual - The preferences.
Return to 1.1 and follow the
procedure.
Network cut o :
give the o command.
900 SNX
Section B - 9
Restart the
"LAMP ON"
procedure.
Restart the
"LAMP ON"
procedure.
Restart the
"LAMP ON"
procedure.
Restart the
"LAMP ON"
procedure.
Restart the
"LAMP ON"
procedure.
Restart the
"LAMP ON"
procedure.
Restart the
"LAMP ON"
procedure.