Robert Juliat D'ARTAGNAN 930 SNX Dossier Technique page 25

1.2. Untimely extinction of the lamp.
2. USING THE " ANALOG " MODE
2.1. The ballast and the CAD are on ;
the" lamp on" command is given,
but the lamp does not switch on.
2.2. Untimely extinction of the lamp.
robert juliat
Route de Beaumont F 60530 Fresnoy-en-Thelle phone: +33 (0)3.44.26.51.89 - fax: +33 (0)3.44.26.90.79 - www.robertjuliat.fr
DOSSIER TECHNIQUE
DECOUPES MSR 2500W
message displayed :
LAMP OFF
CHECK SECURITY
message unchanged.
message unchanged.
message displayed :
RJ LAMP LIGHTING
TRY FAILURE
message displayed :
LAMP FAILURE
CHECK SECURITY
message unchanged.
Message in
start-up display :
" RJ LAMP OFF "
Return to 1.1 and follow the
procedure.
Network transient failure : give the
o command, or switch o
the mains for 30 sec.
Check the analog command cable :
the command has not been
received.
( refer to sections A - 5 & A - 11 )
Return to 1.1 and follow the
procedure.
Return to 1.1 and follow the
procedure.
Network transient failure : give the
o command, or switch o
the mains for 30 sec.
Command signal failure :
check the cable
( refer to sections A - 5 & A - 11 )
900 SNX
Section B - 7
Restart the
"LAMP ON"
procedure.
Restart the
"LAMP ON"
procedure.
Restart the
"LAMP ON"
procedure.
Restart the
"LAMP ON"
procedure.