Locating Malfunctions; Locating Malfunctions Of The Motor; Locating Malfunctions Of Transmissions And Pokers; Instructions To Order Spare Parts - Enarco VIB-BAR E-BATT Manuel D'instructions

8 LOCATING MALFUNCTIONS

8.1 LOCATING MALFUNCTIONS OF THE MOTOR

PROBLEM
THE MOTOR DOES NOT WORK

8.2 LOCATING MALFUNCTIONS OF TRANSMISSIONS AND POKERS

PROBLEM
THE MOTOR WORKS OVERLOADED
AND IT OVERHEATS
THE POKER DOESN'T VIBRATE

9 INSTRUCTIONS TO ORDER SPARE PARTS

9.1 INSTRUCTIONS TO ORDER SPARE PARTS
1.- Every spare parts order must include PART CODE NUMBER AS STATED IN THE PARTS LIST.
We recommend including the MACHINE SERIAL NUMBER.
2.- The identification plate with serial and model number is located as shown in the point 2 of this
manual.
3.- Let us to know the right shipping instructions, including the wished route, the address and the
consignee complete name.
4.- Do not return the parts without authorisation, the return is done with freight prepaid.

9.2 INSTRUCTIONS TO REQUEST WARRANTIES

1.- The warranty is valid for 1 year after the purchasing of the machine, the warranty will cover parts
with manufacturing defects. In any case the warranty will cover a malfunction due to improper usage
of the equipment.
2.- In all warranty requests THE MACHINE MUST BE SENT TO ENARCO, S.A. or to an
AUTHORIZED DEALER, always including the complete address and name of the consignee.
3.- The Technical Assistance Service will immediately notify to the customer if the warranty is
accepted and, if requested, it will send a technical report.
4.- The warranty will be void if any equipment has been previously handled by personnel outside of
ENARCO, S.A. or not authorized by it.
ENARCO, S.A., reserves the right to modify any part of this manual without prior notice.
NB:
CAUSE/SOLUTION
1.- Check the battery is completely inserted in the right position.
2.- Check the battery charge level.
1. Excess or lack of grease in the flexible shaft
2. The bearing of the poker is damaged
3. The movement of the poker is limited or stuck
4. Excessive wearing of the flexible shaft due to extreme
curves
1. The shaft of the transmission is broken
2. Water or dust got into the poker tip
3. The bearing is blocked due to the grease of the
flexible shaft came into the bearing.
4. The bearing is damaged due to the poker has been
working out of the concrete for a long time and that has
caused overheating.
5. The bearing is damaged due to the poker was hardly
beaten in the tube
6. The pendulum or the cone are excessively worn
VIB-BAR E-BATT - FLEXIBLE SHAFT AND POKER
CAUSE/SOLUTION
TBP0.5m / VIB-BAR
en
11
ABP38