Starting The Engine; Eu Declaration Of Conformity - Birchmeier M 225-20 Mode D'emploi

Starting the engine

Close the choke
3 to 4 times operate the pump of the carburetor.
In the summer or when the temperature is higher or the engine is warm enough, it will start with the choke half or fully open.

Move throttle lever to medium– and low-speed position.

Set the gas control handle to elevated speed.

Lightly actuate the recoil starter a few times.
If, after pulling several times, the engine does not start, try again with the choke partly open, or finally fully open. The starter line
should not be pulled out completely.

When the engine has started, slowly open the choke and set the gas handle to a lower speed until, after a short
while, the engine is warm.

A order that you may spray with the maximum possible comfort, adjust the length In of the shoulder straps so
that the weight of the sprayer when on your back is uniformly distributed between the hips.
 To de-aerate the unit, keep the revolver valve open until fluid emerges from the spray nozzle.
Operating the sprayer
Spraying
 The spraying pressure can be varied adjusting the speed of the engine. High speed produces high pressure.

Spray fungicides and insecticides at half to full speed depending on the size of droplets desired (fine droplets).

Herbicides are applied at or slightly above idling speed, by using a special herbicide nozzle or the BIRCHMEIER spray-
shield for herbicides (large droplets).

The fluid in the chemical tank is stirred by the return from the pump.
If the chemical tank is empty, turn off the engine (to avoid the pump running dry).
.

EU Declaration of Conformity

We Birchmeier Sprühtechnik AG
Im Stetterfeld 1
CH 5608 Stetten
hereby declare that the motorized backpack sprayers
Model: M 225-20
M 225-20 BBA
M 225-20 Profi
M 225-20 BBA Profi
described below conforms to the relevant fundamental safety and health requirements of the appropriate EU Directives both in
its basic design and construction as well as in the version marketed by us.
Relevant EU Directives:
EU Machinery Directive 2009/127/CE
Harmonised standards applied:
EN ISO 12100:2010
Appropriate internal measures have been taken to ensure that series-production units conform at all times to the requirements
of current EU Directives and relevant standards.
The signatory is empowered to represent and act on behalf of the company management.
Stetten, November 2011
M. Zaugg
Head of Development & Construction
Art. No. 114 454 05
114 454 06
114 454 08
114 454 09