Whirlpool WEG730H0DS0 Fiche Technique page 7

CODE WHAT IS IT?
F2E0 Keypad Disconnected
The main control no longer sees the keypad.
F2E1 Stuck Keypad
A keypad has been pressed for an extended period
of time. This could be the result of the user pressing
a keypad for too long.
WHEN CAN IT OCCUR? RECOMMENDED CORRECTIVE ACTION PROCEDURE
Within 60 seconds 1.
of the keypad being
2.
disconnected.
3.
4.
5.
6.
7.
8.
9.
10. Plug in range or reconnect power
11. Verify operation is normal. Enter the diagnostic mode to view
Within 120 seconds of 1.
a keypad being pressed
and held.
2.
3.
4.
5.
6.
7
Unplug range or disconnect power.
Inspect keypad connection to main control (connector P12).
If connection loose/unplugged, reconnect.
Replace all parts and panels before operating.
Plug in range or reconnect power. Allow 60 seconds for main
control to identify keypad. If error code reappears, go to
Step 5. If the error code does not reappear, go to Step 9.
Unplug range or disconnect power. Inspect keypad connector,
keypad cable, and main control connector P12 for signs of
damage (cracked locking tab, bent pins, etc.). If damage
found, go to Step 8.
Replace all parts and panels before operating.
Plug in range or reconnect power. Allow 60 seconds for main
control to identify keypad. If error code reappears, go to
Step 8. If the error code does not reappear, go to Step 9.
Replace components in the following order of likelihood of failure
a. Keypad cable
b. Keypad
c. Main control
Replace all parts and panels before operating.
the "Faults" screen. Press START TIME or DELAY START to
clear each Fault code(s).
Disconnect power to the range (wait 30 seconds before
reapplying power). If the error code reappears, go to Step 2. If the
error code does not reappear after 120 seconds, go to Step 6.
Unplug range or disconnect power.
Replace the keypad.
Replace all parts and panels before operating.
Plug in range or reconnect power
Verify operation is normal. Enter the diagnostic mode to view
the "Faults" screen. Press START TIME or DELAY START to
clear each Fault code(s).