Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FOR SERVICE TECHNICIAN'S USE ONLY
CODE
WHAT IS IT?
F1E0 EEPROM Communication Error
The main control is locked up due to an unexpected
communication event. This is often corrected by
cycling power.
Failure/Error Display Code Repair Procedures
WHEN CAN IT OCCUR?
Immediately after the
main control sees an
unexpected event.
RECOMMENDED CORRECTIVE ACTION PROCEDURE
1.
Cycle power to the range (wait 30 seconds before reapplying
power). If the error code reappears, go to Step 2. If the error
code does not reappear after 120 seconds, go to Step 6.
2.
Unplug range or disconnect power.
3.
Replace main control board.
4.
Replace all parts and panels before operating.
5.
Plug in range or reconnect power.
6.
Verify operation is normal. Enter the diagnostic mode to view
the "Faults" screen. Press START TIME or DELAY START to
clear each Fault code(s).
6
Publicité
Table des Matières
