Whirlpool WEG730H0DS0 Fiche Technique page 5

6. Press the number 3 or 6 keypads until "Usage" is displayed, then press
the Start keypad.
7. Select the "On" time for the different modes (all time in hours).
8. Press the number 3 or 6 keypads until "Version" is displayed, then press
the Start keypad.
9.
Verify the software version.
10. Press the number 3 or 6 keypads until "Display" is displayed, then press
the Start keypad.
11. Verify that all the segments of the display are lit.
12. Press the number 3 or 6 keypads until "Control Reset" is displayed, then
press the Start keypad.
13. Press the Start keypad to reset the control for soft control reset.
14. Press the number 3 or 6 keypads until "Faults" is displayed, then press
the Start keypad.
15. Press the number 3 keypad to navigate through the errors and see all
the recorded faults.
16. Press the number 3 or 6 keypads until "Auto Test" is displayed, then
press the Start keypad.
Automatic Test is the enhanced diagnostic procedure where the
■
control tests all the relay loads and Input/Output on the control
automatically and reports the failures and faults.
17. Open and close the oven door when directed.
To test the keypad, press each keypad. After all keypads are
■
pressed, wait approximately 15 seconds, and then "press cancel"
will be displayed. Press the Cancel keypad to continue with the
diagnostic testing.
18. Press the appropriate keypad to indicate Yes or No for the component
relay for desired testing. The control will display the appropriate
component fault code(s) in the format "F#E#" (the description of the
component fault is also displayed).
19. If no faults are detected, the control screen will read "Control good -
No Fault Found."
20. Do not replace the control unless the display screen indicates the control
is not working or you are directed to do so.
NOTES:
The Cancel keypad can be pressed at any time when the control is in the
■
Diagnostic Mode or any of the submenus. Pressing the Cancel keypad
twice will return the control to the time of day screen.
Entering Diagnostic Mode will cancel any active oven operation.
■
Enter the Diagnostic Mode only after the oven is cool.
■
Automatic test is a self-diagnostic function built into the oven control.
■
Diagnostic Mode automatically times out and returns to the time of day
■
screen after 5 minutes.
To erase all error codes: Enter Diagnostic Mode by pressing
■
CANCEL>CANCEL>START within 5 seconds. Press the number 3 or 6
keypads until "Faults" appears. Press START TIME or DELAY START to
clear all error codes.
5