Whirlpool WEG730H0DS0 Fiche Technique page 15

FROM
Thermofuse (TOD)
P4-2
Bake igniter (gas) P2-3
Broil igniter (gas) P4-2
Main cavity bake P2-3
element
Broil element P4-2
Drawer element P3-1
Convection fan motor P5-3
Cooktop element (single) H1
Single, dual, and triple
Term H1(Single
burner elements
only) Term 4, 4A
(double only)
Term 1, 4, 4A
(triple only)
NOTES:
In gas models, the convection fan comes on only after a 5-minute delay in any applicable cooking modes.
■
In electric models, the convection fan comes on immediately in any applicable cooking modes.
■
RESISTANCE: MEASURE
TO
WITHOUT POWER APPLIED
P6-1 Closed circuit 0Ω nominal
The switch closed at 170°F
± 11°F (76 °C ± 6°C) and opens
at 280°F ± 8°F (138°C ± 4°C).
Current = 25 Amp
Voltage = 240 Volt
W (Neutral) P6-3 40 - 400Ω nominal at room
temperature.
W (Neutral) P6-3 40 - 400Ω nominal at room
temperature.
P15-1 10 - 40Ω nominal.
P15-1 10 - 40Ω nominal.
W (Neutral) P6-3 10 - 40Ω nominal.
W (Neutral) P6-3 80 - 95Ω
H2 23-83Ω nominal.
Term 4, 4A Thermal switch closes/opens
at 150°F (66°C) to turn on/off
hot surface indicator light.
Term 2 A Thermal limiter 0Ω opens at
1100°F (593°C).
15
NOTES
Hi Limit switch will open if temperature
exceeded.
Disconnect bake igniter pigtail connection.
Disconnect broil igniter pigtail connection.
For voltage measure in Bake mode; will
cycle between Bake and Broil elements on
when heating.
For voltage, measure in Broil mode. Only
broil element on when heating.
For voltage measure in Bake mode; will
cycle between Bake and Broil elements on
when heating.
Convection fan runs in all convection
cycles and during Bake preheat.
Infinite switch cycles On/Off when hot.
Cooktop On indicator light is on when any
burner is turned on.
NOMINAL
VOLTAGE
240 VAC
120/240
VAC
120 VAC
240 VAC
240 VAC
240 VAC
120 VAC
240 VAC
120 VAC
240 VAC