Stanley SPT-182-570 Traduction De La Notice Originale page 27

ensure the plates are secured with equal force
between 90N.m(6 ft-lbs) and 130N.m(9 ft-lbs).
4. Slide the friction wheel assembly back
onto the hex shaft. Make sure the shift
lever pin is in place in the bearing housing.
Follow the steps above in reverse order to
reassemble components.
Charging Battery (if so equipped
Follow the instructions below to charge
battery:
1. Remove battery cover.
2. Disconnect negative (black) battery cable
first, then positive (red) battery cable.
3. Take battery out of the tray and place it on
bench or other well-ventilated place.
4. Connect positive (+) lead of charger to
positive (+) terminal, and negative (-) lead
to negative (-) terminal.
5. Charge the battery at two and a half amps
for ten hours.
6. Reinstall battery into unit.
9 . Transport
To travel from one work area to another:
1. Set throttle to slow or part-throttle position.
2. On wheeled model, press down on handle bars
enough to raise front of unit slightly off surface; on
tracked model, move the track lock lever into the
transport position.
3. Engage drive clutch without engaging auger
clutch.
Always shut off engine, remove key, and
close fuel shut-off valve when transporting
unit on a truck or trailer. Do not transport
machine while engine is running.
Use extra care when loading or unloading unit
onto trailer or truck.
Secure unit chassis to transport vehicle. Never
secure from rods or linkages that could be
damaged.
10. ENVIRONMENTAL
Recycle unwanted materials instead
of disposing of them as waste. All
tools, hoses and packaging should
be resorted, taken to the local
recycling center and disposed off in
an environment-friendly safe way.
27
G
B