What To Do If - ZANKER ZKB7630 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2
1
7
Carefully lift (step 1)
and remove (step 2) the
panels of glass one by
one. Start from the top
panel of glass.
Clean the glass panels with water and soap. Dry the
glass panels carefully
Installing the door and the glass panels
When the cleaning is completed, install the glass pan-
els and the oven door. Do the above steps in the oppo-
site sequence.

What to do if...

Warning! Refer to "Safety information" chapter.
Problem
The appliance does not heat
up.
The oven lamp does not op-
erate.
Steam and condensation
collect on the food and in
the appliance.
Possible cause
The appliance is deactivated.
The clock is not set.
The necessary settings are not set.
The automatic switch-off is on.
The Child lock is on.
The fuse in the fuse box is released.
The oven lamp is defective.
You left the dish in the appliance for too
long.
The middle panel has a decorative frame. When you in-
stall this panel, make sure that the screen-printing zone
looks to the inner side of the door. Make sure that after
the installation the surface of the glass panel frame on
the screen-printing zones is not rough when you touch
it.
Make sure that you install the top panel of glass in the
seats correctly. Refer to the illustration.
Activate the appliance.
Set the clock.
Do a check of the settings.
Refer to "Automatic switch-off".
Refer to "Deactivating the Child Lock".
Do a check of the fuse.
If the fuse is released more than one
time, contact a qualified electrician.
Replace the oven lamp.
Do not let the dishes stay in the appli-
ance for longer than 15-20 minutes af-
ter the cooking is completed.
Remedy
33

Publicité

Table des Matières
loading

Table des Matières