ZANKER ZKB7630 Notice D'utilisation page 31

• Clean the front of the appliance with a soft cloth with
warm water and cleaning agent.
• To clean metal surfaces use a usual cleaning agent
• Clean the oven interior after each use. Thus you can
remove dirt more easily and it does not burn on.
• Clean stubborn dirt with a special oven cleaner.
• Clean all oven accessories (with a soft cloth with
warm water and cleaning agent) after each use and
let them dry.
• If you have nonstick accessories, do not clean them
using an aggressive agents, sharp edged objects or
dishwasher. It can destroy nonstick coating!
Cleaning the door gasket
• Regularly do a check of the door gasket. The door
gasket is around the frame of the oven cavity. Do not
use the appliance if the door gasket is damaged.
Contact the Service Centre.
• To clean the door gasket refer to the general infor-
mation about the cleaning.
Pyrolytic cleaning
Warning! The appliance becomes very hot.
There is the risk of burns.
Important! Do not use Pyrolytic cleaning function and
the hob at the same time (if it is installed with the
appliance). It can cause a damage to the appliance.
Before Pyrolytic cleaning:
1. Remove all removable parts from the appliance.
To remove the shelf supports (if present), refer to
"Removing the shelf support rails".
2. Remove the worst of the dirt manually.
3. Close the oven door correctly.
Using the Pyrolytic cleaning
1. Press
again and again until the display shows
.
– The display shows "Pyro" and
– An acoustic signal sounds to remind you to re-
move all removable parts from the oven.
– The temperature display shows „P1" or „P2"
– The clock display shows "2:00" or "2:30"
– Duration
flashes for approximately 5 sec-
onds.
2. While Duration
the duration for the Pyrolytic cleaning:
– 2:00 for a low degree of dirt,
– 2:30 for a high degree of dirt.
3. Press
The bars on the symbol come on one by one to
show that the temperature in the appliance increa-
ses.
When the appliance is at the preset temperature,
the door locks and the display shows
When the Pyrolytic cleaning is completed, the display
shows the time of day. The oven door is locked. When
the appliance cools down, an acoustic signal sounds
and the door unlocks.
To stop the pyrolytic cleaning at any time, press
End time for Pyrolytic cleaning
You can set the end time for Pyrolytic cleaning
with the clock function End
1. Do again step 1,2 and 3 from above procedure.
2. Press
The display shows an arrow and the symbol
The display shows the time for the end of Pyrolytic
cleaning.
3. Press
the Pyrolytic cleaning.
Removable shelf runners and catalytic panels
To clean the oven cavity remove the shelf runners and
catalytic panels.
Warning! Be careful when you remove the shelf
runners. The catalytic panels are not attached to
the oven cavity and can fall out when you remove the
shelf runners.
Warning! Before maintenance, make sure that
the appliance is cool. There is risk of burns
.
because of residual heat.
flashes, press
to start the Pyrolytic cleaning.
.
.
or to adjust the time for the end of
or to set
.
.
.
31