Daily Use - ZANKER ZKB7630 Notice D'utilisation

3. Set function
and maximum temperature.
4. Run an empty oven for 15 minutes.
This is to burn off any residue from the cavity surface.
Accessories can become more hot than in normal use.

Daily use

Warning! Refer to "Safety information" chapter.
The display
1
Button
/
Setting the oven function
1
1. Push
again and again until the symbol for the
necessary oven function flashes.
The display shows an automatic temperature. If
you do not change the temperature in approximate-
ly 5 seconds, the appliance starts to operate.
2 3
Function
ON/OFF
SELECTOR
RAPID HEAT UP
PYROLYTIC CLEANING
PLUS, MINUS
CLOCK
During this period an odour and smoke can be emitted.
This is normal. Make sure the airflow is sufficient.
1 Cooking function
2 Temperature
3 Time
To switch the appliance on or off.
To set the oven function.
To switch the rapid heat-up function on.
To start the Pyrolytic cleaning.
To adjust the values (temperature and time).
To set the clock function.
2. To change the temperature, push
If there is a power cut, the programmer keeps all
the settings for approximately 3 minutes. After
more than 3 minutes without power supply, you have to
do the settings (also the time of day) again.
If you start an oven function, the symbol of the
2
temperature flashes.
The symbol shows that the temperature in the appli-
ance increases.
When the appliance is at the set temperature, an
acoustic signal sounds and the symbol of the tempera-
ture stops to flash.
Description
or button.
23