Electrical Connection; Very Important - Virtus AIC0071/F Manuel D'installation, Utilisation Et Maintenance

4.3 ELECTRICAL CONNECTION

An AUTHORISED TECHNICIAN should always carry out the appliance's electrical connection.
The legal standards in force in each country on connections to the
mains should be taken into account.
Check that the mains voltage corresponds to that indicated on the
nameplate.
Power cables should be flexible cables with oil-resistant cover, and
should not be lighter than ordinary cable sheath ordinary
polychloroprene or equivalent synthetic elastomer (H05RN-F).
A switch device should be installed next to the appliance for all the
phases, with a gap of a minimum of 3 mm between contacts. This
switch will be equipped with fuses.
The appliance must be earthed, from the connection strip of the
appliance to the earth connection of the main power supply.
The manufacturer will not be held liable for damage originated by
failure to observe this requirement.
To access the connection strip, release the left side panel (Fig.8),
pass the cable hose through the stuffing box on the exterior base
and connect as shown on the strip.
VERY IMPORTANT: Before installing the left side panel, attach the electrical supply hose securely to the
stuffing box.
When several appliances are installed in series, they should be earthed to each other using the point
assigned for this purpose, located in the fryers base, at the back.
The trays are placed in the oven at a maximum height of 1, 6 m. if and
when original accessories are used (except in overlapping ovens
Overlapping ovens or in any other case where the height is exceeded,
it should be applied on the front of the oven, to 1.6 m in height from
the ground and in a clearly visible location, the following adhesive that
is included in the package.
To prevent scalding, do not use cargo containers with liquids or
for cooking foods that become fluids by heating to higher levels
than those that can be easily observable.
.
Fig. 8
49