Installing/Removing The Reel Capsule - Grizzly MTS 30-10 E2 Traduction De La Notice D'utilisation Originale

GB
1. If applicable, unscrew the top (33b)
and bottom (33a) fl anges mounted on
the cutting head holder (19).
2. Screw the protective cover (15) onto
the cutting head holder (19) using the
3 screws (34) enclosed.
Installing the metal cutting blade
(picture 5b):
3. Place the metal cutting blade (18) and
fl anges (33a+b) on the cutting head
holder (19) in the following order:
Bottom fl ange (33a) – metal cutting
blade (18) – top fl ange (33b).
4. Screw on the metal cutting blade (18)
anticlockwise
(35) and with the aid of the maintenance
key (see picture 2, no. 26).
Insert the splint (23).
pic. 5b
15
19
Removing the metal cutting blade
(picture 6):
5. To lock the axle, push the enclosed
metal pin (25) sideways into the hole
provided on the cutting head holder
(19) and on the bottom fl ange (33a).
100
using the fi xing nut
33b
35
18
33a
23
6. Unscrew the fi xing nut clockwise with
the aid of the maintenance key (26)
and remove the top fl ange (33b) and
the metal cutting blade (18).
pic. 6
33a
25
Installing/Removing the Reel
Capsule (Picture 7)
Dismantling the metal cutting blade
is described in the section on "In-
stalling/Removing the Metal Cut-
ting Blade".
Installing the protective cover / thread
reel:
1. Screw the protective cover / reel capsule
(15) onto the protective cover / metal cut-
ting blade (20) using the 3 screws and
nuts (36) enclosed.
Installing the reel capsule:
2. Screw the reel capsule (16) anticlock-
wise
onto the cutting head holder
by hand, as indicated in the diagram.
3. Remove the protective cap on the thread
cutter (14).
26
33b
18
19