Fault Correction - Grizzly MTS 30-10 E2 Traduction De La Notice D'utilisation Originale

GB
Troubleshooting
Problem Possible Cause
Tank empty
Incorrect starting sequence
Engine "flooded"
Engine
does not Sooted spark plugs, incorrect spark
start gap
Spark connection, ignition cable
damaged
Carburettor jets dirty, incorrectly ad-
justed carburettor mix
Blocked fuel filter
Engine ticks
over too Engine cold
quickly
Sooted spark plugs, incorrect spark
gap
Dirty air filter
Engine
does not Carburettor jets dirty, incorrectly ad-
justed carburettor mix
give top
perfor-
mance Incorrect fuel mix
Sealing ring in crank case leaking
Cylinder, piston rings worn
Incorrect ignition
Excessive Incorrectly adjusted carburettor mix Have the carburettor cleaned and
formation
of exhaust/
smoke Incorrect fuel mix
110

Fault Correction

Fill with fuel
Follow the instructions in this manu-
al on starting the machine
Remove some gas, start several
times; remove, clean and dry the
spark plug if necessary
Clean, adjust or replace the spark
plugs
Replace
Have the carburettor cleaned and
adjusted by a specialist workshop
Replace or clean the fuel filter
Warm up slowly
Clean, adjust or replace the spark
plugs
Clean or replace the air filter
Have the carburettor cleaned and
adjusted by a specialist workshop
Fill up according to the instructions
Have the fault corrected by a spe-
cialist workshop
adjusted by a specialist workshop
Fill up according to the instructions