Charging The Battery; Removing / Inserting The Battery; Recharging The Battery - Grizzly ART 2420 Lion Traduction De La Notice D'utilisation Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 56

Charging the battery

Do not expose the battery to
extreme conditions such as heat
or impact. Risk of injury from
escaping electrolytic solution!
After eye/skin contact, rinse the
affected areas with water or a
neutraliser and consult a doctor.
Charge the battery in a dry room
only.
Prior to attaching the charger,
check that the battery's outer sur-
face is clean and dry.
There is a risk of injury due to elec-
tric shock.
Only use the original charger from
the package to charge the battery.
Mind not to charge the appliance
for more than 8 hours at a time. If
you do, the battery and the appli-
ance may be damaged and longer
charging times would be a waste
of energy. Excessive charging will
void the warranty.
Charge the battery before the first
time of use. Do not briefly charge
the battery several time in a row.
Recharge the battery when you
notice that the appliance is beco-
ming slower.
If a fully recharged battery lasts
for considerably shorter operating
times, the battery is used up and
needs to be replaced. Only use an
OEM spare battery available from
our Customer Service.
Always take heed of the applicable
safety instructions as well as the
environmental protection regulati-
ons and information.
The warranty excludes all defects
caused by improper handling.

Removing / inserting the battery

E
1. To remove the battery (18) from
the appliance, press the release
button (18a) on the battery and
pull out the battery.
2. To insert the battery (18), place
it on the guide track (4) and
push it back into the appliance.
It will audibly snap in.
Do not insert the battery until
the appliance is fully assembled.
Risk of injury!

Recharging the battery

Allow a freshly charged battery
(18) to cool down for approx. 15
minutes before inserting it into the
battery charger (19).
1. Remove the battery (18) from
B
the appliance, as necessary.
2. Inser the battery (18) in the
charging compartment of the
battery charger (19). It will audi-
bly snap in.
3. Plug the battery charger (19) into
a mains outlet.
4. When the battery is fully re-
charged unplug the battery
charger (19) from the mains.
5. Press the release button (18a)
on the battery (18) and pull the
battery out of the battery charger
(19).
GB
31

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Art 2420 lion set

Table des Matières