Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Changing the Reel
1. Switch off the engine.
2. Place the equipment on the
ground and ensure that no fuel
leaks and that the equipment is
safely supported.
3. Unscrew the fixing screw (29) an-
ticlockwise
capsule (19) with the thread reel
(20).
4. Place the new reel in the reel cap-
sule and push both ends of the
thread through the thread outlet
eye (30). Ensure that the spring
(31) is in the correct position.
5. Push the thread reel (20) into the
reel capsule (19) and retighten
the fixing screw (29) clockwise
.
6. Trim the thread cord to approx.
13 cm in order to strain the en-
gine less in the start and warm-
up phase.
Maintenance Intervals
Regularly carry out the maintenance work listed in the "maintenance intervals" table.
Regular maintenance prolongs the life of the equipment. It also gives optimum cutting
performance and avoids accidents.
Table "Maintenance Intervals"
Machine Part
Screws, nuts, bolts
Air filter
Fuel filter
Spark plug
Fuel hoses
Complete machine
Operating handle
Cutting head
Cleaning the Air Filter
and take off reel
Action
Check, tighten
Clean or replace
Replace
Clean/adjust/replace
Check, replace if necessary
Check, clean if necessary
Check for function
Check correct installation
Never operate the equipment with-
out the air filter otherwise dust and
dirt enter the engine and result in
damage to the machine. Keep the
air filter clean.
1. Switch off the engine.
2. Undo the screw (32) on the air
filter cover (4) and take off the
air filter cover from the air filter
housing (33).
3. Remove the air filter (34) from
the filter cover (4).
4. Clean the filter with soap and
water and allow it to dry in the air
Never use petrol!
5. Reinstall the filter in reverse order.
Replace the air filter if it is worn, dam-
aged or heavily soiled.
Operating Hours
Before
Each Use
GB
10
20
81
Publicité
Table des Matières
