Machine Jacking; Transporting Machine; Storing Machine - Tennant 1530 Manuel De L'opérateur

5. To adjust the brush height back to the original
factory set height, place the machine on a hard
floor surface and lower the brush base to the floor.
Following the adjustment procedure, adjust the
brush height so that the brush bristles just touch
the floor then turn both knobs 3 full turns
counter-clockwise (Figure 33).
FIG. 33

MACHINE JACKING

Use the designated locations under the solution tank
for jacking up the machine. Use a piece of wood to
distribute the machine weight load (Figure 34).
Stop the machine on a flat level surface and block
machine tires before jacking up the machine.
FIG. 34
FOR SAFETY: When servicing machine, block
machine tires before jacking machine up.
FOR SAFETY: When servicing machine, jack
machine up at designated locations only. Block
machine up with jack stands.
Tennant 1530 (04- 11)

TRANSPORTING MACHINE

When transporting the machine by use of trailer or
truck, be certain to follow tie- down procedures below:
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
1. Set the machine in the Travel Mode.
2. Load the machine using a recommended loading
ramp.
3. Position the front of the machine up against the
front of the trailer or truck. Once machine is
positioned, lower the brush base and turn off key.
4. Place a block behind each drive wheel to prevent
machine from rolling.
5. Place tie- down straps over the top of the machine
to prevent it from tipping. It may be necessary to
install tie-down brackets to the floor of your trailer
or truck.
FOR SAFETY: When transporting machine, use a
recommended ramp when loading/unloading
into/off truck or trailer, use tie- down straps to
secure machine to truck or trailer.

STORING MACHINE

1. Drain and rinse tanks thoroughly.
2. Store the machine in a dry area with the brush
base in the raised position.
3. Remove the recovery tank cover to promote air
circulation.
ATTENTION: If storing the machine in freezing
temperatures, be certain to drain tanks, purge
pump and remove the solution tank filter located
under the machine at rear. Damage due to freezing
temperatures is not covered by warranty.
WARNING: Do Not Use Outdoors. Do Not
Expose To Rain. Store Indoors.
OPERATION
17