Operation; Display Elements; Controls - Lovibond SD 310 Oxi Mode D'emploi

4. Operation

4.1 Display elements

3
ppm mmHG hPa
4
MAX
HLD
DIF MIN
5
ok CAL SAL Logg m hPa
6
7 8

4.2 Controls

1 Oxi
SD 310_2 07/2018
mg/l %O
2
1
abs
2
°C
°F
9
10
1. Main display: Displays current oxygen
value, see also Chapter 6,
(H 2)
(shift with
2. Secondary
display:
Displays sensor temperature
or absolute pressure
(display changes in cycles,
see also Chapter 6, LcD.2)
3. Main display units
4. Evaluation of battery status or by pressing
Evaluation of the sensor status
5. Display elements for representation of the
minimum/maximum/saved measurement
value
6. OK: indicates a stable measurement
7. CAL:
Calibration display
8. SAL: indicates that the salinity correction
is active
9. appears if logger function was selected or
blinks if logger cycle is active
10. Secondary display units
On/Off switch, light
Press briefly: Activate lamp
or switch on device
Press and hold: Switch off device
Set / Menu:
Press briefly: Changes oxygen display
(see also Chapter 5)
Press for 2 sec. (menu): Calls up the configuration
min / max:
Press briefly: Displays the minimum or
maximum measured value
Press for 2 sec.: Deletes the respective value
Configuration level (see Chapter 6):
- Confirms entry, return to measurement
cal:
Press briefly: Sensor status at last calibration
is displayed.
Press for 2 sec.: Starts the oxygen calibration
button)
:
35