Set-Up; Configuration Of The Device - Lovibond SD 310 Oxi Mode D'emploi

5. Set-up

Connect the electrode, switch on the device with the
After the segment test
(e.g. if a zero point or pitch correction of the temperature sensor was made).
The device is now ready for measurement.

6. Configuration of the device

i
Some menu items are accessible depending on the current device setting (e.g. some
are locked when they contain logger data).
Press and hold "menu" for two seconds for the configuration, whereby the menu
("SEt" main menu) is opened.
Select the desired menu branch with "menu".
Jump to the corresponding parameters which you can then change.
Selection of parameters
Pressing again switches back to the main menu and saves the settings.
Close the configuration.
If the "menu" and "store" buttons are pressed together and held down
for longer than 2 seconds, the settings are reset to the factory settings. If data
i
in the single value logger (logger: 'Func Stor') is first shown as 'rEAd Logg' menu:
see also Chapter 8 Data logger for this purpose. If no button is pressed for a period of more
than two minutes, the configuration is canceled. No changes made up
to that point are saved!
SD 310_2 07/2018
, the device briefly shows information about its configuration:
button.
37