Important Safety Instructions - Angelcare AC027 Manuel De L'utilisateur

transmitter and receiver are working properly and are
within range of each other – check periodically and
when changing location of the Nursery Unit.
19. DO NOT use the baby monitor near water
Care should be taken so that objects DO NOT fall
onto units and that liquids are not spilled into either
unit or Sensor Pad through its openings.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
DO NOT EXPOSE TO RAIN OR MOISTURE
20. Keep monitor AWAY from heat sources
(such as stoves, radiators, etc.). Heat can
damage the case or electrical parts.
21. ALWAYS place both the Nursery Unit and
the Parent Unit on a flat solid surface in
an upright position that allows for proper
VENTILATION. DO NOT place on sofas, cushions,
beds, etc. which may block ventilation or anywhere
that would muffle the sound or interfere with the
normal flow of air.
22. The baby monitor can only be used
between 10°C and 40°C (50°F and 104°F).
WARNINGS AND SAFETY
INSTRUCTIONS - BATTERY SPECIFIC
WARNING
Do not ingest the battery, Chemical Burn Hazard.
This product contains a coin/button cell battery.
If the coin/button cell battery is swallowed, it can
cause severe internal burns in just 2 hours and can
lead to death. Keep new and used batteries away from
children. If the battery compartment does not close
securely, stop using the product and keep it away
from children. If you think batteries might have been
swallowed or placed inside any part of the body,
seek immediate medical attention.
23. The Wireless Sensor Pad uses a
replaceable Button Cell Lithium Battery. Only
use the Angelcare recommended replacement
battery (see Technical Specification).
• Danger of explosion if the wrong battery is used
or if replaced incorrectly. Refer to User's Guide for
correct battery installation.
• DO NOT short circuit supply terminals.
24. DO NOT mix old and new batteries and only
use Angelcare recommended replacement
batteries (see Technical Specification).
25. The Button Cell Battery represents a small part
and a choking hazard – KEEP away from children!
26. Exercise care in handling batteries in order
not to short out the batteries with conducting
materials such as rings, bracelets and keys.
27. Overcharging, short circuiting, reverse
charging, mutilation, or incineration of
batteries must be avoided to prevent one or
more of the following occurrences: release of toxic
materials, release of hydrogen and/or oxygen, gas
and rise in surface temperature.
28. DO NOT attempt to recharge batteries
provided with or identified for use with this
product that are not intended to be charged.
The batteries may leak corrosive electrolyte or explode.
29. Incorrect polarity installation of the
batteries in the end product must be avoided.
Reverse insertion of batteries can cause charging,
and that may result in leakage or explosion.
30. Remove batteries from units if you store
the product over 30 days because the batteries
could leak and damage the product.
31. Discard 'dead' batteries as soon as possible
since 'dead' batteries are more likely to leak in a
product. If a battery has leaked or vented, discard
product responsibly.
32. DO NOT store this product, or the
batteries provided with or identified for use
with this product, in high-temperature &
high humidity environments and avoid direct
sunlight.
33. CAUTION
• Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
• Battery cannot be subjected to high or low extreme
temperatures, low air pressure at high altitude
during use, storage or transportation.
• Replacement of a battery with an incorrect type can
result in an explosion or the leakage of flammable
liquid or gas.
• Disposal of a battery into fire or a hot oven, or
mechanically crushing or cutting of a battery, can
result in an explosion.
• Leaving a battery in an extremely high temperature
surrounding environment can result in an explosion
or the leakage of flammable liquid or gas.
• A battery subjected to extremely low air pressure
may result in an explosion or the leakage of
flammable liquid or gas.
• The applied nameplate is located at the product rear
enclosure.

IMPORTANT SAFETY INSTRUCTIONS

34. Sensor Pad –
• If your crib does not have a solid, stationary,
completely flat, firm surface including a spring or
slat base, place a hard board between the crib base
and the Sensor Pad, to ensure correct operation
(see specification on STEP 2).
• The Sensor Pad functions with standard crib sprung
and foam mattresses and not memory foam (partial
or full), hollow frame construction mattresses and
water beds. Please consult Angelcare if unsure of
mattress compatibility.
35. Only use attachments/accessories
and replacement parts specified by the
manufacturer. Any mounting of the product
should follow the manufacturer's instructions.
• DO NOT position this product on an unstable cart,
stand, tripod, bracket or table. The product may fall,
causing serious injury to a child or adult and serious
damage to the product.
• Use ONLY the stand sold with the product.
E E
N N
3 3