Montage Des Jupes De Coque Latérales; Montage Du Suceur - Numatic Nacecare TTB 3226 Mode D'emploi

PROBLEM
Machine will not operate
Vacuum will not operate
Poor water pick-up
No brush / scrub function
Little or no water flow
Machine just 'stops' while
operating
Failure to rectify the problem or in the event of a breakdown contact your
Nacecare dealer or the Nacecare Technical helpline
CAUSE
Missing or blown fuses
Key in the 'OFF' position
Low battery charge
Emergency stop in 'OFF' mode
Waste tank full switch stuck or clogged
Floor tool in raised position
Waste water tank full
Waste-water tank full
Clogged / blocked vacuum hose
Loose hose connections
Debris basket filter clogged / blocked
Separator filter clogged / blocked
Poor separator seal
Damaged separator seal
Damaged / split vacuum hose
Damaged floor-tool blades
Low battery charge
No brushes fitted
Brush deck raised
Clean-water tank empty
Clean-water tank filter blocked/ clogged
Incorrect water flow setting
Brush deck raised
Too much load on the brush system
+44 (0) 900 1 905 785 0038
24
Trouble-Shooting
SOLUTION
Fit or replace fuse (page 9)
Turn key to 'ON' position (page 9)
Charge batteries (page 19)
Reset emergency stop (page 14)
Inspect and clean switch (page 17)
Lower floor-tool (page 13)
Empty waste water tank (page 14)
Empty waste-water tank (page 14)
Remove and clean (page 17)
Push tight connections
Remove and clean (page 17)
Remove and clean (Page 17)
Clean and refit (page 17)
Renew (contact service dept)
Renew (contact service dept)
Renew (contact service dept)
Recharge batteries
Check and fit (page 11)
Lower brush deck (page 12)
Fill clean-water tank (page 11)
Remove and clean (17)
Adjust as desired (Page 14)
Lower brush deck (page 13)
Reset the machine using the key and
decrease the brush load to best suit
the floor type (page 14)