Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
W 570 Flexio
14. Adjusting the Material Volume
(Standard spray attachment)
Set the material volume by turning the regulator on the trigger guard of the spray gun.
(Fig. 10)
lower material volume
higher material volume
15. Setting the Amount of Air (Fig. 11)
Depending on the viscosity of the material to be sprayed and the finish of
i
the object to be coated, it may be advisable to vary the amount of air. Very
low viscosity materials, such as watery glazes do not have to be atomised
with the maximum amount of air. In this case it is advisable to reduce
the amount of air and thus minimize the spray vapour.
This also applies for the use of the Detail and Corner&Reach spray attachment
(accessory).
Slide the air volume regulator (fig. 11, 1) into the desired position:
thin paint
thick paint (e.g. interior wall paint)
16. Spray Technique
The spray result depends heavily on the smoothness and cleanliness of the
i
surface to be sprayed. Therefore the surface should be carefully prepared and
kept free of dust.
•
Cover all surfaces not to be sprayed.
•
Cover screw threads or similar parts of the target object.
Important: Start at the edge of the area to be sprayed. Start the spray
i
movement first of all, and then press the trigger. Avoid interruptions
within the area to be sprayed.
•
The spray movement should come from the arm, not just from the wrist. This ensures that
a uniform distance is maintained between the spray gun and the spray surface during
the spray operation. Select a distance of 5 - 15 cm, depending on the desired spray jet
width. When you are using interior wall paint, the distance should be about 20-30 cm
(approx. one stirring rod in length).
Fig. 12 A/ 12 B:
Fig. 12 C:
turn anti-clockwise (-)
turn clockwise (+)
CORRECT Even distance to the object.
INCORRECT An uneven distance will result in uneven paint
application.
Level I
Level II
GB
29
Publicité
Chapitres
Table des Matières
