WAGNER W 575 FLEXIO Instructions D'utilisation Originales page 43

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

W 570 Flexio
Problem
Coating material
drips from the
nozzle
Atomisation too
coarse
Spray jet pulsates
Coating material
causes "paint tears"
Too much fog of
coating material
(Overspray)
Paint in the
ventilating hose
Poor covering
capacity on the wall
Cause
Nozzle loose
Nozzle worn
Nozzle seal is missing or worn
Coating material assembly at air
cap, nozzle or needle
Coating material too thick
Material volume too large
Nozzle clogged
Air cap assembled incorrectly
Air filter heavily soiled
Too little pressure build-up in
container
Amount of air too low
Coating material in container
running out
Air filter heavily soiled
Nozzle seal is missing or worn
Too much coating material
applied.
Distance to the object too large
Too much coating material
applied
Amount of air too high
Diaphragm soiled
Diaphragm defective
Spray material is too cold
Highly absorbent surface or paint
with poor covering capacity
Distance too large
Remedy
➞ Tighten
➞ Change
➞ Change
➞ Clean
➞ Dilute
➞ Reduce the material
volume
➞ Clean
➞ Snap air cap properly
into place (fig. 19, 2)
➞ Change
➞ Tighten container
➞ Increase air quantity
(Level: II)
➞ Refill
➞ Change
➞ Change
➞ Reduce the material
volume
➞ Reduce distance
➞ Reduce the material
volume
➞ Decrease air quantity
(Level: I)
➞ Clean the diaphragm
➞ Replace the diaphragm
➞ The material you are
spraying should be at
room temperature
➞ Cross spray (Fig. 13)
➞ Closer to the object
GB
35

Publicité

Table des Matières
loading

Table des Matières