Switching Off; Safety Features - EUROM Force 1800 Livret D'instructions

water jet does not cause objects to move out of place or fall or fly around and cause damage. Also
select a safe location for yourself!

Keep your work environment clean and tidy.

The high-pressure jet can cause damage to, for example, tyres if you move the jet too close. Always
maintain a minimum distance of 30 cm from the object to be cleaned! Always adjust the distance to
the object to be cleaned (and therefore the pressure) appropriately.

Work from the bottom to the top in the case of vertical surfaces.

Prevent water from splashing onto undesired places.

Do not move the cleaner by pulling the electrical cable. Do not lift the machine up with the cable.
Prevent damage to the cable caused by oil, solvents, sharp edges, etc. Do not cover the machine
during use.

Do not use the machine in an insufficiently ventilated room.

It is forbidden to clean surfaces containing asbestos with high-pressure.

If the machine is not used for longer than 5 minutes it must be switched off.

SWITCHING OFF


Switch the machine off (Button to O / OFF).

Close the water supply.

Allow any pressure to escape by squeezing the trigger until no more water comes out of the nozzle.

Close the safety lock on the handle.

Pull the plug out of the socket.
STORAGE

Before clearing the machine away, the water must be removed from the pump, the hose and the
accessories. You do this by switching the machine off with the switch and disconnecting the water
supply hose. Now start the machine again and squeeze the handle. Allow the machine to operate
until no more water comes out of the jet lance. Then switch the machine off immediately. Never allow
it to 'run dry'!

Remove the plug from the socket, wind the hose up and hang the cable on the hook.

Place the handle and the lances in the holders on the machine.

The machine must be stored frost-free. If this is impossible, have the machine suck in anti-freeze
before you store it. Remember to flush the machine thoroughly with water before using it again! If the
machine nevertheless freezes, have it checked before use. Frost damage is not covered by the
guarantee. Never start a frozen high-pressure cleaner!

SAFETY FEATURES

The nozzle is fitted with a 'lock' for safety. If you push the button to the left, the handle is locked and will
not function. Unlock the handle by pushing this switch back to the original position.
The motor is fitted with a thermal safety feature that switches it off when it overheats. In principle, it will
start again automatically when it is sufficiently cooled. But it is better to switch the machine off for 5 to 10
minutes, wait, and then start it again. Identify the cause of the overheating and remove it. If this problem
recurs, stop using the machine and contact your supplier / repair service.
The pressure regulator can reduce the pressure when it exceeds the values set by the manufacturer.
MAINTENANCE
Attention: Always take the plug out of the socket before you execute maintenance!

Flush the water supply hose, the high-pressure hose, the jet lance, the
nozzle and other accessories thoroughly before you use them.

Carefully remove dust, sand or other dirt from the connections.

Regularly clean the nozzle with the pin supplied and then flush it
thoroughly (against the direction of the jet). To do this you must remove the
nozzle from the lance.
21