Tips For Use - EUROM Force 1800 Livret D'instructions

7. Connect a normal ½" garden hose (reinforced) of min.
5m. and max. 25m. to the water supply and turn it on for
a short time in order to flush any dirt out of the hose.
Now use a quick connector to connect the hose to the
water inlet.
Fitting the terrace cleaner:
Attention!

Place the cleaner as close as possible to the water supply.

The cleaner must be placed on a strong, flat and horizontal surface (handle up).

The water supply must supply at least the water consumption of the machine (400 l/h)! The pump
must always be supplied with sufficient water. 'Dry operation' causes damage.

The water temperature may not exceed 40°C. The pressure of the water supplied may not exceed
0.7 MPA (7 bar).

Only use clean water with this machine. Impurities or aggressive chemicals damage the machine!
OPERATION

Turn the On/Off switch to the O / OFF position.

Check that the specifications of the socket that you wish to use correspond with those on the type
plate of the machine. If this is the case, insert the plug into the socket.

Open the water supply completely.

Unlock the safety lock by pushing the button to the right

Now squeeze the trigger for several seconds in order to de-aerate the hose.

Switch the machine on by switching the On/Off button to I / ON. The motor will start briefly, but will
stop again as long as the trigger is not squeezed.

Now squeeze the trigger – the machine will start.

The automatic start/stop system means that the motor only works when the trigger is
squeezed.

The jet produced by the jet lance can be adjusted from narrow to wide by turning the head of the
lance. Never do this while spraying!

The Rotating jet nozzle creates a narrow rotating jet.

The terrace cleaner is intended for the cleaning of hard, even, flat surfaces such as terraces, small
streets, steps, (garden) walls, etc. The cap provides protection from water splashing back. Attention:
the powerful jets can damage softer materials such as paint and wood, etc!

TIPS FOR USE


When the water jet leaves the nozzle it causes the handle to recoil. You must therefore ensure that
you are standing in a stable position and have a firm grip. Also ensure that the high pressure of the
Important: Always point the jet down!
20