Inserting The Melitta Claris ® Water Filter - Melitta LATTEA Mode D'emploi

 Inserting the Melitta Claris
A Melitta claris
After starting up the appliance for the first time, please insert the water filter into
the appliance. If you use the filter, you will decalcify the appliance less frequently
and the water hardness will be set on hardness level 1 automatically (see page 60 in
this regard). the service life of your machine will be extended thanks to the reliable
protection against lime scale. The water filter should be changed regularly (every 2
months), at the latest however it must be changed when the symbol for the water filter
is shown in the display.
Prerequisite: The appliance is switched off.
•
simultaneously press the button for brewing strength
On / Off button
→
The symbol for the water filter
the symbol for the drip tray
•
empty the drip tray and then reinsert it.
→ the symbol for the water reservoir
• Flip up the cover of the water reservoir and pull the water reservoir up
and out of the device.
• empty the water reservoir.
•
screw the Melitta claris
water reservoir.
• Fill the water reservoir with fresh water to the Max. mark and reinsert it in
the appliance.
→
the symbol for the milk shower
• take off the milk canister and place a larger bowl under the milk shower.
• turn the rotary switch for the milk shower (Fig. A, no. ) clockwise to
open the milk shower.
→ the symbol for the milk shower
under the milk shower.
Heft_Lattea_EU.indd 53
water filter for filtering out lime scale is included with the appliance.
®
for more than 2 seconds.
water filter into the thread on the floor of the
®
water filter
®
flashes during the entire change procedure.
is illuminated.
is illuminated.
is illuminated.
is flashing. Water runs into the bowl
and the

09.07.2009 15:28:57