Melitta LATTEA Mode D'emploi page 69

→ the standby symbol
as long as the brewing unit is out of the machine.
Caution!
Danger of damaging the brewing unit
–
During the cleaning program only remove the brewing unit at the time
specified here.
9 Leave the brewing unit as it is (do not move or twist the components of
the brewing unit).
10 thoroughly rinse off the brewing unit as a whole from all sides under
running water.
11 Let the brewing unit drip dry.
12 Place a cleaning tab in the brewing unit (Fig. C).
13 Put the brew unit back into the appliance and turn the handle of the brew
unit anticlockwise to the stop to lock the brew unit.
→ the symbol for cleaning
not illuminated. the symbol for the water reservoir
14 Insert the four catches of the cover in the back of the appliance and swing
the cover to the left until it engages.
15 Flip up the lid of the water reservoir (Fig. A, no. ) and pull the water
reservoir up and out of the appliance. Fill the water reservoir to the Max.
mark with fresh tap water and reinsert it.
16 slide the coffee outlet (Fig. A, no. ) all the way down.
17 Press the button for brewing strength
cleaning program.
→
the integrated cleaning program will continue. this process lasts approxima-
tely 5 minutes. Water flows out of the outlet as well as in the interior of the
the appliance into the drip tray. subsequently, the symbol for the drip tray
will be illuminated.
Heft_Lattea_EU.indd 69
and the symbol for cleaning
will continue to flash; the standby symbol
to continue with the integrated
will flash alternately,
is
is illuminated.

09.07.2009 15:29:09