Inserting The Melitta ® Claris ® Water Filter - Melitta Caffeo Lattea Guide D'utilisation

6 Inserting the Melitta
A Melitta Claris
®
and other contaminants. Please only insert it after starting up the appliance
for the first time. If you use the filter, you will have to descale the appliance less
frequently and the water hardness will automatically be set to hardness level 1
(see page 59). The service life of your appliance will be extended thanks to this
reliable protection from limescale. The water filter should be changed regularly
(every 2 months); at the latest, however, it must be changed when the symbol for
the water filter
Prerequisite: The appliance must be switched off (see „Switching on and off"
on page 52).
• Simultaneously press the button for coffee strength
OFF button
→ The symbol for the water filter
procedure. The symbol for the drip tray
• Empty the drip tray and then reinsert it.
→ The symbol for the water tank
• Put the water filter in a glass with fresh tap water for several minutes
before you insert it.
Open up the flap of the water tank (Fig. A, no. 7) and pull the water tank
•
up and out of the appliance.
• Empty the water tank.
• Screw the Melitta
bottom of the water tank.
• Fill the water tank to the max. mark with fresh tap water and reinsert it.
→ The symbol for the milk shower
• Take off the milk canister and place a vessel under the milk shower.
Turn the rotary switch for the milk shower (Fig. A, no. 11) clockwise to
•
open the milk shower.
Heft_Lattea_EU_2_3.indd 53
water filter is supplied with the appliance for filtering out limescale
®
is shown on the display.
for more than 2 seconds.
Claris water filter carefully into the thread on the
® ®
Claris water filter
® ®
flashes during the entire change
is illuminated.
illuminates.
will be illuminated.
and the ON/
53
09.04.2014 14:04:18