Melitta LATTEA Mode D'emploi page 76

Malfunction
the brew unit
cannot be re-inserted
after it has been
removed.
Buttons for single-
cup and two-cup
operation flash
alternately with the
On / Off button
Continuous flashing
of all buttons
If you have additional questions please contact our service hotline at
+49 (0) 571/86 1900.

Heft_Lattea_EU.indd 76
Cause
the brew unit is not cor-
rectly sealed.
the drive is not in the
correct position.
Brewing unit is missing or
is not inserted correctly
Brewing chamber is
overfilled
system error
Measure
check whether the handle for
the locking mechanism is cor-
rectly locked in place.
switch the appliance OFF and
then ON again, then press the
operating buttons for single-
cup dispensing and two-cup
dispensing simultaneously for
more than 2 seconds. the drive
will move into position. Replace
the brew unit and check that it
is correctly locked in place.
Insert the brewing unit properly
switch off the appliance and
switch it on again via the
On / Off button (repeat if
necessary) until standby mode is
displayed.
switch off the appliance and
switch it on again via the
On / Off button; if this does
not solve the problem send the
appliance to the service organi-
zation.
09.07.2009 15:29:13