Starting And Ending The Welding Process; Rs 350 M / Mw Pro Welding Parameters - Magmaweld RS 350 M PRO Manuel D'utilisation

28 Operation

3.8 Starting and Ending the Welding Process

EN
• Determine the Coarse Adjustment ", Fine Adjustment" and Wire Feed Speed from the welding parameters table of your machine according to the
diameter of the wire you will use, the type of gas you will use and the thickness of the material to be welded, and set your machine to these settings.
Wire Diameter
Material Thickness
Coarse Adjustment Range
Fine Adjustment
Wire Feeding Speed
Current
Voltage
• You can start welding after making sure that you comply with all safety rules and take the necessary precautions.
• During welding, instantaneous welding voltage will be displayed in voltmeter and instantaneous welding current will be displayed in ammeter.
When not welding, leave the torch in such a way that it does not touch the workpiece, the welding pliers, the hood of
the machine and the trigger does not remain pressed.
• After you have finished working with the welding machine, allow the machine to cool down and turn the on / off switch to "0". Unplug the machine
and close the gas cylinder.

3.9 RS 350 M / MW PRO Welding Parameters

• The welding parameters were obtained by horizontal welding with solid wire in laboratory conditions. Values may vary depending on the application
and ambient conditions.
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
RS 350 M / MW PRO - RS 450 M / MW PRO - RS 550 M / MW PRO
www.magmaweld.com