Magmaweld RS 350 M PRO Manuel D'utilisation page 6

6 Safety Precautions
EN
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
• Keep the machine turned off and disconnect cables when not in use.
• Before repairing the machine, remove all power connections and/or connector plugs or turn off the
machine.
• Be careful when using a long mains cable.
• Make sure all connections are tight, clean, and dry.
• Keep cables dry, free of oil and grease, and protected from hot metal and sparks.
• Bare wiring can kill. Check all cables frequently for possible damage. If a damaged or an uninsulated
cable is detected, repair or replace it immediately.
• Insulate work clamp when not connected to workpiece to prevent contact with any metal object.
• Make sure that the grounding of the power line is properly connected.
• Do not use AC weld output in damp, wet, or confined spaces, or if there is a danger of falling.
• Use AC output ONLY if required for the welding process.
• If AC output is required, use remote output control if present on unit.
Additional safety precautions are required when any of the following electrically hazardous
conditions are present:
• in damp locations or while wearing wet clothing,
• on metal structures such as floors, gratings, or scaffolds,
• when in cramped positions such as sitting, kneeling, or lying,
• when there is a high risk of unavoidable or accidental contact with the workpiece or ground.
For these conditions, use the following equipment in order presented:
• Semiautomatic DC constant voltage (CV) MIG welding machine,
• DC manual MMA welding machine,
• DC or AC welding machine with reduced open-circuit voltage (VRD), if available.
Procedures for • Turn off the electric power.
Electric Shock • Use non-conducting material, such as dry wood, to free the victim from contact with live parts or wires.
• Call for emergency services.
If you have first aid training;
• If the victim is not breathing, Administer cardiopulmonary resuscitation (CPR) immediately after
breaking contact with the electrical source. Continue CPR (cardiac massage) until breathing starts or
until help arrives.
• Where an automatic electronic defibrillator (AED) is available, use according to instructions.
• Treat an electrical burn as a thermal burn by applying sterile, cold (iced) compresses.
Prevent contamination, and cover with a clean, dry dressing.
RS 350 M / MW PRO - RS 450 M / MW PRO - RS 550 M / MW PRO
www.magmaweld.com