RS 350 M / MW PRO - RS 450 M / MW PRO - RS 550 M / MW PRO
4.4 Error Codes
It gives an error message when the mains voltage is wrong or thermal. If you do not want the welding performance to be affected during installation,
the parameters such as wire diameter, torch, consumables used in the torch, wire type, wire diameter and gas type should be considered.
Error Code
Thermal
E01
Protection
Temperature Sensor
E05
Reading Failure
www.magmaweld.com
Error
• The machine's duty cycle rate may have been
exceeded
• Fan may not be operating
• The air inlet and outlet ducts may have been
blocked
• The machine operating environment can be
extremely hot or lack of air
• Temperature sensor may have failed or there
may be an electrical connection problem
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
Reason
• Wait for a while to allow the machine to cool
• Visually inspect the fan for proper operation.
• Open the air ducts
• Ensure that the machine is placed in an area
• Contact the authorized service
Maintenance and Service
Solution
down. If the failure disappears, try to run the
machine at lower amperage values
Please contact the authorized service if it
does not operate
where it can work operate comfortably
33
EN