Annex 1 - Fine Settings In The Wire Feed Unit - Magmaweld RS 350 M PRO Manuel D'utilisation

34

Annex 1 - Fine Settings in the Wire Feed Unit

RS 350 M / MW PRO - RS 450 M / MW PRO - RS 550 M / MW PRO
ANNEX 1 - FINE SETTINGS IN THE WIRE FEED UNIT
EN
You can make fine adjustments through the panel above the wire feed motor.
1- Free Wire Feed Button: As long as the button is held pressed, the wire is fed and the gas valve does not operate. You can use this button to feed
the wire into the torch.
2- Free Gas Button: As long as the button is held pressed, gas flow is enabled and wire feed does not run. You can use this button to change the gas
in the system after a gas change.
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU www.magmaweld.com