A suitable plug must be connected by a qualified electrician. Make sure that the grounding cable is present. After connecting the plug to the cable, do

not attach it to the outlet at this stage.

2.4 Connection to Mains

When plugging the power plug into the outlet, make sure that the on/off switch is set to "0".

Support should be received from authorized persons (qualified electricians, etc.). Check the phase voltage before connecting the machine to the mains.

The plug must be plugged to the outlet once it is observed to be correct. Turn the coarse on/off switch to position "1" to start the machine. Make sure

that the indicators and LEDs on the control panel are lit and the cooling fan is operating.

2.5 Connections for TIG Welding

Check for the correct mains voltage before connecting the machine to the mains.

When plugging the power plug into the outlet, make sure that the power switch is set to "0" in the turned-off position.

• Start the machine with the on/off switch and check whether the LEDs are on and the cooling fan is working.

Tungsten Electrode

Recommended TIG

Diameter (mm)

Welding Current

1.6

2.0

2.4

2.5.1 Torch Connections

• Insert the TIG torch's plug into the negative pole welding socket and tighten it by turning to the right. Attach the torch trigger connector that came

with the machine to the trigger control cables of the torch. Then connect the connector to the trigger control socket.

• Connect the gas hose of the torch to the gas outlet.

• Water cooling unit is an optional accessory for cooling the water cooled torches in demanding applications.

www.magmaweld.com

30-130

45-180

70-240

USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU

Installation

Table des Matières