26
Operation
3.5 Placing the Wire Spool and Wire Feeding Process
EN
• Unscrew the screw of the wire transport system by turning it. Insert the welding wire roller
parallel to the wire ground and always from the bottom to the wire transport system shaft and
re-tighten the screw (Figure 20).
Over-tightening the nut will prevent the wire from feeding and may cause failures. Under-tightening of the nut may cause
the roller to be released at the time wire feed is stopped and mixed after a while. For this reason, do not connect the nut too
tightly or too loosely.
• Pull and lower the pressure lever on the wire feed rollers, which means bring the pressure rollers to idle position.
• Remove the welding wire from the point where the roller is connected and cut off the end with a side chisel.
If the end of the wire is missed, the wire can jump like a spring and damage you and others.
• Pass the wire through the wire entry slot without releasing the wire into the rollers and into
the torch through the rollers (Figure 21).
• Press the pressure rollers and lift the pressure lever
• Turn the on/off switch to position "1" to start the machine
• Press the trigger until the wire comes out from the tip of the torch, while observing that the welding wire roller rotates freely then push and release
the trigger a few times to check for any loosening of the winding
bearing system.
• Re-attach the nozzle and contact nozzle to the torch when the wire comes out from the tip of the torch
• Drive the wire on a
board and make the appropriate wire pressure adjustment
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
.
.
. If loosening and/or backwinding is observed, tighten the screw of the wire
and cut the tip of the wire
RS 350 M / MW PRO - RS 450 M / MW PRO - RS 550 M / MW PRO
Figure 20 : Placement of Wire Basket
Figure 21 : Feeding the Wire to Rollers
BOARD
.
.
www.magmaweld.com