Maintenance And Service; Maintenance; Every 6 Months; Non-Periodic Maintenance - Magmaweld RS 350 M PRO Manuel D'utilisation

RS 350 M / MW PRO - RS 450 M / MW PRO - RS 550 M / MW PRO

MAINTENANCE AND SERVICE

• Maintenance and repairs to the machine must be carried out by a qualified personnel.
Our company will not be responsible for any accidents that may occur by unauthorized interventions.
• Parts that will be used during repair can be obtained from our authorized services. The use of original spare parts
will extend the life of your machine and prevent performance losses.
• Always contact the manufacturer or an authorized service specified by the manufacturer.
• Any unauthorized repair attempt other than by the manufacturer during the warranty period will cause all warranty
provisions to be void.
• Always comply with the applicable safety regulations during maintenance and repair.
• Before performing any work on the machine for repair, disconnect the machine's power plug from the power
supply and wait for 10 seconds for the capacitors to discharge.

4.1 Maintenance

Every 3 Months
• Do not remove the warning labels on the device. Replace the worn/torn labels with the new ones. Labels
can be obtained from the authorized service.
• Check your clamps and cambles. Pay attention to the connections and the durableness of the parts. Replace the
damaged/defective parts with the new ones. Do not ever make aditions to/repair the cables.
• Ensure adequate space for ventilation.

Every 6 Months

• Clean and tighten fasteners such as bolts and nuts.
• Check the lead of the electrode pliers and earth pliers.
• Open the side covers of the machine and clean with low pressure dry air. Do not apply compressed air to electronic
components at close range.
• Periodically replace the water in the tank of the water cooling unit with fresh, hard water and protect it against
freezing with antifreeze.

4.2 Non-Periodic Maintenance

• The Wire Feeding Mechanism must be kept clean and the roller surfaces must not be lubricated.
• Always remove any deposits on the mechanism with dry air each time you replace a welding wire.
• The consumables on the torch should be cleaned regularly. It should be replaced if necessary. Make sure that these
materials are original products for long-term use.
NOTE: The above mentioned periods are the maximum ones that should be applied if no problems are encountered in your device.
Depending on the work load and contamination of your work environment, you can repeat the above processes more frequently.
Never operate the machine when covers are open.
www.magmaweld.com USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
Maintenance and Service 31
EN