Installation - Alpine iDA-X100M Mode D'emploi

Installation

Caution
Do not block the unit's heat sink, thus preventing air circulation.
If blocked, heat will accumulate inside the unit and may cause a
fire.
Heat sink
Caution
When you install this unit in your boat, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
• Stick the supplied cover sheet on the surface of the unit.
Cover sheet
This unit
• The main unit must be mounted within 35 degrees of the horizontal
plane, back to front.
Less than 35°
1
* If the installed mounting sleeve is loose in the main unit, the pressure
plates may be widened slightly to remedy the problem.
2
Detachable
Front Panel
• For the screw marked "*
mounting location.
3
Removal
Mounting Sleeve
(Included)
Pressure Plates*
This unit
Remove mounting sleeve from the main unit (see
"Removal" on page 41).
Hex Nut (M5)
*
Metal Mounting Strap
Ground Lead
1
*
Battery
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground to a wire
attached directly to the boat's negative battery
terminal.
1
", use an appropriate screw for the chosen
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming
from the left rear of the iDA-X100M. Connect all other
leads of the iDA-X100M according to details
described in the CONNECTIONS section.
Slide the iDA-X100M into the instrument panel until
it clicks. This ensures that the unit is properly
locked and will not accidentally come out from the
instrument panel. Install the detachable front panel.
1. Remove the detachable front panel.
2. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
This unit
3. Pull the unit out, keeping it unlocked as you do so.
Instrument Panel
Screw
1
Bolt Stud
This unit
Bracket keys
(Included)
41
-EN