Alpine iDA-X100M Mode D'emploi page 43

USB cable connection
Insert a USB cable into the unit, and fix with a lock screw.
iPod Connection (sold separately)
USB connection
Connect USB cable to an iPod with iPod Dock interface cable.
iPod Dock interface Cable
Full Speed™ connection
Connect Full Speed™ connector to an iPod with FULL SPEED
connection cable (KCE-422i).
FULL SPEED™
Connection Cable
(KCE-422i) (Sold separately)
Remove the iPod
Remove the iPod from FULL SPEED™ Connection Cable or iPod
Dock interface cable.
• If USB is connected, after the unit has been changed to a source
other than the iPod, remove the iPod. If the iPod is removed in the
iPod mode, data may cause damage.
• If sound is not output or the iPod is not recognized even when the
iPod is connected, remove the iPod once, then connect it again, or
reset the iPod.
• Before connecting the iPod to this unit, set the EQ function of iPod to
OFF.
42
-EN
USB Cable
USB cable
TM
USB memory Connection (sold separately)
Connect USB memory
Connect USB memory to USB cable.
USB memory
Remove USB memory
Pull out USB memory squarely from the USB cable.
USB memory
• When removing USB memory, pull it out straight.
• If sound is not output or USB memory is not recognized even when
USB memory is connected, remove USB memory once, then connect
it again.
• Change to a source other than the USB memory mode, then remove
the USB memory. If the USB memory is removed in the USB memory
mode, data may be damaged.
Portable Audio Player Connection (sold separately)
Connect Portable audio player
Connect the cable supplied with a Portable audio player to
the USB cable.
Supplied cable for the Portable audio player
Remove Portable audio player
Disconnect the Portable audio player from the supplied
player cable.
• Refer also to the Owner's Manual of the Portable audio player.
USB cable
USB cable
USB cable