Alpine iDA-X100M Mode D'emploi page 39

Indication for Portable audio player Mode
Current Error
• Abnormal current is run to the USB connector device (an error
message may be displayed if the USB device that is not
compatible with the unit is connected).
- Attempt to connect another Portable audio player.
USB Device Error
• A Portable audio player that is not supported by the unit is
connected.
- Attempt to connect another Portable audio player.
No USB Device
• A Portable audio player is not connected.
- Make sure the Portable audio player is correctly connected and
the cable is not excessively bent.
• There are no songs in the Portable audio player.
- Download songs to the Portable audio player and connect to
this unit.
No Support
• Text information that is no supported on the unit has been input.
- Use an Portable audio player in which text information is input
that is supported on the unit.
• A sampling rate/bit rate not supported by the unit is used.
- Use a sampling rate/bit rate that is supported by the unit.
• A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
- Make sure the Portable audio player is set to MTP.
• Communication error
- Turn the ignition key off, and then set to ON again.
- Verify in the display after reconnecting the Portable audio
player to the connection cable.
• Caused by the Software Version not being compatible with this
unit.
- Update the Portable audio player Software Version. For details,
refer to the Owner's Manual of player.
- Reset the Portable audio player.
38
-EN
Indication for CD Changer
• Protective circuit is activated due to high temperature.
- The indication will disappear when the temperature returns to
normal operating range.
• Malfunction in the CD Changer.
- Consult your Alpine dealer. Press the magazine eject button and
pull out the magazine.
Check the indication. Insert the magazine again.
If the magazine cannot be pulled out, consult your Alpine
dealer.
• Magazine ejection not possible.
- Press the magazine eject button. If the magazine does not eject,
consult your Alpine dealer.
• A disc is left inside the CD Changer.
- Press the eject button to activate the eject function. When the
CD Changer finishes the eject function, insert an empty CD
magazine into the CD Changer to receive the disc left inside
the CD Changer.
• No magazine is loaded into the CD Changer.
- Insert a magazine.
• No indicated disc.
- Choose another disc.