General Transmitter Layout; Initializing The Transmitter / Battery Holder For The First Time - Napoleon Bayfield GDS25N-1 Manuel D'installation

7.1

general transmitter layout

Transmission
Flame ON
7.2

initializing the transmitter / battery holder for the first time

Install the 4 AA batteries into the Proflame 2 battery holder, note the polarity of the batteries and insert as
A.
indicated on the cover (+/-).
Ensure the 3 position slider switch is switched to the "REMOTE" position (middle position).
B.
Press the reset/programming button, use a small object such as a paper clip in order to reach the button
C.
marked PRG, as shown in the illustration below.
The battery holder will beep 3 times to indicate that it's ready to synchronize with the transmitter.
D.
Install the 3 AAA batteries into the transmitter, as shown in the photograph below, then press the ON
E.
button, The battery holder will beep 4 times to indicate that the transmitter's command is accepted.
note:
The initializing process must be completed within 10 seconds of pressing the reset / program button (PRG).
BATTERY HOLDER
SLIDER SWITCH
RESET/PROGRAM
BUTTON (PRG)
Blower
note:
Transmitter is optional with this model.
operation
Key Lock
Low battery alarm
Room
Temperature
CPI mode
Light
TRANSMITTER
W415-2207 / C / 08.23.18
EN
33