7.1 General Transmitter Layout; 7.2 Initializing The Transmitter/Battery Holder - Napoleon STARfire Serie Mode D'emploi

Masquer les pouces Voir aussi pour STARfire Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7.1
general transmitter layout
Transmission
Flame ON
(NOT AVAILABLE WITH THIS MODEL)
7.2
initializing the transmitter/battery holder for the fi rst time
A.
Install the 4 AA batteries into the Profl ame 2 battery holder, note the polarity of the batteries and insert as
indicated on the cover (+/-).
B.
Ensure the 3 position slider switch is switched to the "REMOTE" position (middle position).
C.
Press the reset/programming button, use a small object such as a paper clip in order to reach the button
marked PRG, as shown in the illustration below.
D.
The battery holder will beep 3 times to indicate that it's ready to synchronize with the transmitter.
E.
Install the 3 AAA batteries into the transmitter, as shown in the photograph below, then press the ON
button, The battery holder will beep 4 times to indicate that the transmitter's command is accepted.
note:
The initializing process must be completed within 10 seconds of pressing the rest/program button (PRG).
BATTERY HOLDER
SLIDER SWITCH
RESET/PROGRAM
BUTTON (PRG)
Blower
7.0 operation
Key Lock
Low battery alarm
Room
Temperature
CPI mode
Light
TRANSMITTER
W415-2372 / A / 11.14.19
EN
39

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Starfire hdx35ntStarfire hdx35pt

Table des Matières